|
On the Keystone website I was able to find the the service manual. It stated that the rough opening should be 3/8 bigger for both height and width. For the two windows in my slideout, either the opening is to big or/and the window is not centered but sitting on the bottom of the opening. Just in the last couple weeks the upper right corners have pulled away from the sidewall leaving a gap. Looking in the gap you can see the cut edge of the rough opening just below the exterior flange. Even if the window was sitting all the way down in the opening there should only be a 3/8 " gap in the rough opening. There should still be sufficient coverage by the flange on the outside wall.
The dealer is going to look at it. I would like to see them take it apart so I can measure the rough opening and the window.
|