View Single Post
Old 11-10-2013, 08:54 AM   #3
BlindGuyNAR
Senior Member
 
Join Date: Feb 2013
Location: Arkansas
Posts: 109
Here is my setup when I tested for clearance.

I was at nearly 90 deg and had 4-5 inches to spare. I could have went to 90 without hitting. I'd have to be backing at an extreme up angle to hit and wouldn't want to be at 90 deg then anyway. Being at that angle really torques the trailer axles so you wouldn't want to do it unless you have to.

With my B&W set at up at the most rear point "I" don't need the slider. Your results might be different.


__________________
2012 SuperDuty CC KR 6.7
B&W hitch
Load lifters with on board compressor

2013 Mountaineer 346 LBQ

If no one from the future comes to stop you from doing it, how bad of a decision can it really be?
BlindGuyNAR is offline   Reply With Quote