[hankpage]

Originally Posted by azlee56

I tried to get channels on the Sansui 1900 bedroom TV in our 08 Montana 3500RL (whew that was mouthful). BUT, I couldn't get many channels. This happened to our the living room tv, but then I learned about the booster button and they all came in fine. This TV is back at the booster button and only gets a few Spanish channels and says "digital signal low". The booster is on and this is just to get channels with the attenna, not cable or satellite.

Did the channel search with the booster on and off and it was the same stuff picked up. Takes it forever to scan them too.

Any suggestions?

If you go to Antenna Point and enter your present location it will tell you what direction to aim your antenna. Most of the digital channels are on UHF and aiming is critical. Every time you move the antenna you must rescan for channels. Setting the tv to just scan OTA (AIR) channels will shorten the scan time. Hope this helps, Hank ............... Just sitting by a nice campfire at night requires no scanning. ..... I know, I like my tv too.

This does not help with the electrical interference but may help get more channels