No ac power to outlets

[Pirkens]

2020 keystone zinger 34bh. Replaced converter and wall gfci. DC circuit is good,however, no ac to outlets, ac or micro. Have power to main panel and breakers but gfci will not reset.It like another gfci is tripped somewhere. Cannot locate another gfci only one next to range. The bathroom outlet is marked gfci but is a standard outlet, any ideas thank you...

[govols380]

You did two things at the same time, converter and gfi. First, check power cord, then ac input and output at converter, and also at power distribution center, and then ac input and pass through at gfi outlet.

Start at the beginning and verify toward the disfunction.

[chuckster57]

You may have mis wired the GFCI outlet. There are 2 sets of Romex and the “live” side has to be wired to the FEED and the other side that continues on goes to the LOAD side.

[flybouy]

Sounds like you have lost one line of your 50 Amp service. Are you plugged into a 50 Amp receptical? Have you turned the breaker off then back on? Don't trust just a visual check, you must cycle the breakers off then on to ensure that they are reset.